Can you hook up 4 ohm speakers up to a 2 ohm amp?

How Hide TV Cables Audiophiles are always looking for new ways to get the most out of their audio equipment. Over the years people have found creative ways for enhancing sound quality beyond just buying more expensive speakers. There are two techniques in particular that we will talk about here: While neither of these techniques are strictly necessary, they can potentially give you better sound.

Speakers are usually a combination of two specific speakers: Both Bi-Wiring and Bi-Amping try to improve sound quality by isolating these components from one another.

Jun 16,  · If you are wiring as bridged, you must be “certain” that the speakers are 8 ohm. If the speakers wind up being 4 ohm speakers and you wire 2 speakers in “bridged mode”, you will be droping the resistance to 2 ohms and the amp WILL blow up on : Resolved.

My installer tried two kits to integrate the Kenwood with the factory JBL amp. With both kits, the sound would end up fading in and out and there was very little sound to the rear speakers. The front speakers sounded great when they weren’t fading in and out. The installer then made a wiring harness and just bypassed the JBL amp. He also installed a couple of crossovers. It sounded like garbage. It sounded like the music was playing from inside a coffee can. Played with all the settings, very little improvement.

They insisted it would work. So I bought the harness and installed it last night. The front speakers sound great, no fading in and out like with the harness the installer tried. But there is very little signal to the rear speakers. Triple checked all connections, everything is properly connected.